Our Services

Get 15% Discount on your First Order

[rank_math_breadcrumb]

HELP 18

PLEASE REVIEW THE INFO

Data Collection: Linear Motion

Linear motion refers to the motion of an object along a straight line.

This experiment will study in activity 1 the linear motion in a horizontal direction and in activity 2 the linear motion in a vertical direction.


Material you need:

· Tennis ball or any small ball [do not use soccer ball or basketball]

· Meter stick or tape measuring

· Timer [you can use your phone]


Activity 1:

· Mark on a smooth horizontal surface (floor) a starting point and then using your mearing tape mark along the floor 2m, 4m and 6 m.

· Start rolling the tennis ball on the horizontal surface (not too fast not to slow) before the starting point. When the ball passes the starting point start the timer and then when the ball passes the 2m point stop the timer. Record the time value in the table under Trial 1.

· Repeat rolling the ball and recording the time the ball takes to travel the 2m distance for two more trials. Record the time values in Table 1 (second column).

· Repeat the starting and stopping of the timer in measuring how long the ball takes to travel 4m.Write the time values in the third column.

· Repeat the starting and stopping of the timer in measuring how long the ball takes to travel 6m.Write the time values in the fourth column.

· Calculate the time average for each distance

· Calculate the average speed:


Average speed = Distance / Time



(All lengths should be in “s”meter and all times should be in “seconds”)

Data Table 1: Rolling a ball along a horizontal surface

Time (s):

2-m Distance

Time (s):

4-m Distance

Time (s):

6-m Distance

Trial 1

Trial 2

Trial 3

Average time (s)

Average speed (m/s)


Activity 2:

· Drop the ball from a height d = 2m and use the timer to record the time it takes the ball to reach the floor.

· Repeat this step 7 times and write the time values in the table 2

· Calculate the average time and then calculate t2.

· Calculate the experimental value of acceleration due to gravity “g” by using this equation

Data Table 2: Time trials to drop an object from 2 m

Item

Data

Trial 1 Drop time, t, (s)

Trial 2 Drop time, t, (s)

Trial 3 Drop time, t, (s)

Trial 4 Drop time, t, (s)

Trial 5 Drop time, t, (s)

Trial 6 Drop time, t, (s)

Trial 7 Drop time, t, (s)

Average drop time (s)

t2 (s2) =

Experimental

Calculate the percentage error for acceleration due to gravity” g”. The accepted value is g = 9.8 m/s2.

If your number is very different, please repeat the activity 2.



Questions


:

1. Write Newton’s first Law of Motion (Please see Chapter 2).

2. What is happening with the speed of the ball as the distance traveled on the floor increases (activity 1)? Why do you think is that?

3. What is happening with the speed of the ball as it falls toward the ground (activity 2) Why do you think is that?

Share This Post

Email
WhatsApp
Facebook
Twitter
LinkedIn
Pinterest
Reddit

Order a Similar Paper and get 15% Discount on your First Order

Related Questions

LAB 10

PLEASE REVIEW THE INFORMATION BELOW  Image Characteristic for Mirror and Lens A spherical mirror is a reflective surface that can be concave or convex. Making the analogy with a spoon, the reflective surface of a concave mirror (spoon) “holds” the water and the reflective surface of a convex mirror (spoon)

LAB 9

PLEASE REVIEW THE INFORMATION BELOW  Reflection and Refraction Reflection and refraction are two commonly observed optical properties of light. Whenever light strikes the surface of some material at an angle, part of the wave is reflected, and part is transmitted (or absorbed). The reflection of light rays from a plane

General physics

I need help with this home work assignment  Practice Makes Perfect – Final Comprehensive Quiz General Physics Lecture/Lab (PHY 213) V. M. Edwards, Ph.D., Professor Last Name__________________________ First name______________________ Score___________ SI Base Units Quantity SI Unit (word) SI Unit (abbreviation) 1. Mass _________________ _________. 2. Time _________________ _________. 3. Length

space proj 3

Read Extortion – the short sci-fi story. After you finish the story, look up the discussion questions ( using discussion questions attachment ONLY!!) , choose twenty (20) which you find especially interesting, and write a short answer for these using ONLY!! the extortion document attached.

lab 8

please review the info below Magnetic Fields This lab uses a Physlet simulation. Click here In this lab the simulation generates magnetic field lines due to permanent magnets such as ferromagnetic materials (like iron) and Earth. Magnetic field “lines” are actually loops with a North to South direction. Magnets have

Physics with Cal

I need help with these homework problems 1. The amplitude of the wave shown in the figure is A. A. B. B. C. C. D. D. 2. The wavelength of the wave shown in the figure is A. A. B. B. C. C. D. D. 3. What is the wavelength

LAB HELP

PLEASE REVIEW INFORMATION  Ohm’s Law Theory Ohm’s law states that the current through a conductor between two points is directly proportional to the voltage across the two points and inverse proportional with the resistance. V = I R V = Voltage I = Current R = Resistant Procedure The lab

LAB

PLEASE REVIEW THE INFO  Experiment Pendulum and the Calculation of g Experiment Pendulum and the Calculation of g Lab 6 -Simple Pendulum Discussion and review A simple pendulum consists of a mass (“bob”) suspended from a light string of length L. The bob is pulled sideways such as the string

help 20

please review the info  Conservation of Energy Name: Date: Objectives: To explore concepts of kinetic, potential and total energy with and without friction. Theory: Kinetic Energy, KE=½mv2. Gravitational Potential Energy PE=mgh Total Mechanical Energy, E=KE+PE= mgh + ½mv2 Conservation of energy law: Ef = Ei or Ef – Ei =

help 21

info below FRICTION The lab activity uses a simulation developed by University of Colorado Friction Simulation Click Here Select “Friction” on the bottom of the screen, then select all the right corner options. Start with the m=50kg wood box on the floor and increase the applied force such as the

HELP 19

INFROMATION BELOW  Lab 3 – Force 1. What is force? 2. What is the unit for force? 3. Analyze each vector diagram and fill in the table below. Vector Diagram Resultant Force (Magnitude and Direction) 4. What is the force on a 1000 kg elevator that is falling freely at

Physics General Phy with cal 213- practice homework problems

Can someone help me with this homework assignmen? Only 15 questions. Last Name _____________________________ First Name ____________________ Major _________________ 1. Complete the following statement: The angular measure 1.0 radian is equal to A) 0.0175°. B) 57.3°. C) 1.57°. D) 3.14°. E) 6.28°. 2. A bicycle travels 141 m along a

help 18

please review the information below . Measurements of Length and Time Objectives To make basic measurements of length and time To practice graphing using spreadsheet software and paper and pencil. 1. Length · Estimate a 1-meter length by putting a pen or pencil at one end of a table and

Astronmy Lab 1

see attachment Lab 1 – Identifying Atomic Spectra       Name: Overview: In this activity you will explore how different types of spectra are made and get a brief overview of what instrument astronomers use to record spectra. Next, you will explore the atomic structure of hydrogen and the energy levels

physics

instruction attached Graphing Lab PHSC 114 Southern Arkansas University TECH Spring ‘23 Lab 3- Graphing Introduction: One of the most effective methods of describing the relationship between two or more types of measurements is to plot a graph. For example, you could plot a graph of distance vs. time and

Quantam Physics

Define Magnetic Vector Potential. Derive an expression for magnetic vector potential of a current loop. Hence find an electric field sector interms of scalar and vector potential 

General Physics with Cal I

Homework assignment Last Name ___________________________First Name _______________________Date ______________ 1. A park ranger wanted to measure the height of a tall tree. The ranger stood 9.50 m from the base of the tree; and he observed that his line of sight made an angle of 65.2° above the horizontal as he